PID Spool Control Fine Wire Drawing Machine , Durable Pulley Wire Drawing Machine

HXE-14DT Fine copper wire drawing machine with annealing machine

I. Quick description

HXE-14DT Fine copper wire drawing machine with annealing machine is used to draw and anneal single bare copper wire from 0.8mm-1.6mm to 0.25mm-0.6mm.

II. Main Technical parameters

1. Usage: Fine copper wire drawing and annealing
2. Inlet diameter: 0.8mm-1.6mm
3. Outlet diameter: 0.25mm-0.6mm
4. Max. mechanical speed: 1500m/min
5. Dies: 14 dies
6. Slip ratio: 15%, Finished capstan slip ratio: 8%
7. Main motor: AC 3 Phase 15KW, Inverter control
8. Take up motor: AC 3 Phase 5.5 kw, Inverter control
9. Take up capacity: 50kg for diameter 300mm iron spool (Customize)
10. Spool size: Diameter 300mm/Max (Customize)
11. Capstans: Ceramic plasma, Drawing capstan 316mm, Final capstan 268mm
12. Capstan lubrication: Water pipe spray
13. Traversing: 110W synchronous motor,transmission by timing belts.
14. Brake: 20KG-M Electromagnetic brake
15. Air pressure: 4-6kg/cm2
16. Annealing pulley: Diameter 120mm
17. Annealing volt: DC50V
18. Annealing current: DC600A
19. Annealing motor power: 30KVA
20. Power source: (customize)
21. Spool control: PID
22. Tension control: Weight balance
23. Machine dimension(L*W*H): 2600mm*1600mm*1900mm, Machine weight:3200kg

III. Components

IV. Advantage and after-self service

A: Advantage

(1). HENGXIE has some world famous parts suppliers, has special lubrication system for the gears and bearing.
(2). Body and other key components and parts are produced by our own factory , quality is reliable.
(3). DC. three-section annealing
(4). Our company’s developing process in more than 10 years.

B: After-self service

Our company for all machine product, since the shipment date, our company free after sale maintenance service guarantee period is:
(1) 1 year for mechanical part.
(2) 6 month for electrical part.

V. Operating procedures

5-1. Open power switch

5-2. According to the wire diameter, choose the dies (Check the die list).

5-3. Use pliers to break the wire to get a smaller section.

5-4. Use pliers to make the wire through the dies, then pull the wire out (Use foot switch to make the machine running in a low speed to make the wire move).

5-5. Wire direction, please check the Drawing for Wire path.

5-6. After make the wire through all the parts, close the annealing door and the spooling door, make the tension swing arm in the lowest position. and in running, the balance arm should be in the horizontal line. No big shake, no up and down frequently.

5-7. Open the Annealing switch, open the Pump, open and adjust the Drawing lubrication oil, Cooling water, Steam, Compressed air.

5-8. Set the length meters, then press the Start button to start the machine.

wire drawing equipment

aluminum wire drawing machine

PID Spool Control Fine Wire Drawing Machine , Durable Pulley Wire Drawing Machine Images